This paper investigates the Surface roughness in the various Aluminium composite. The drilling experiment is performed on specimens Al7075 + 3% Al2O3, Al7075 + 3% Al2O3 + 1% Mica, Al7075 + 3% Al2O3 + 2% Mica, Al7075 + 3% Al2O3 + 3% Mica with high-speed steel twist drills of 5 mm diameter grade M2. ISO 234:1980 is the specification of the drills used in the current work. The drilling experiment takes place with a feed speed of 0.5 mm/rev. For the aluminum composite samples with coolant, the cutting speed is at different speeds of 10, 20, and 30 mm/min. The Surface Measuring Unit of the Stylus type is used to locate the Surface Roughness Ra of the drilled hole surface. The number of iterations completed is five times for the repeatability of effects with the same drilling parameters. The surface roughness had increased with the addition of reinforcement. The 2% mica addition showed a better surface finish than the 3% addition. Scanning Electron Microscopy investigated the Surface Morphological characteristics.