Статьи по ключевому слову "Fatigue"

A methodology for estimating the damage growth rates in layered composites using special fatigue accumulation rules

  • Год: 2023
  • Том: 51
  • Выпуск: 2
  • 18
  • 511
  • Страницы: 81-95

Effect of surface roughness on the fatigue strength of E-glass composite single lap joint bonded with modified graphene oxide-epoxy adhesive

  • Год: 2023
  • Том: 51
  • Выпуск: 2
  • 22
  • 579
  • Страницы: 65-80

Effect of compression precracking on near threshold region for AlSI 4340 steels considering compliance measurements

  • Год: 2023
  • Том: 51
  • Выпуск: 1
  • 21
  • 499
  • Страницы: 151-167

Experimental investigation of the mechanical behavior of honeycomb sandwich composite under three-point bending fatigue

  • Год: 2022
  • Том: 48
  • Выпуск: 2
  • 34
  • 554
  • Страницы: 217-231

An investigation on the growth of fatigue crack between sequentially cold expanded adjacent circular holes in Al 7075 - T651 alloy

  • Год: 2021
  • Том: 47
  • Выпуск: 3
  • 30
  • 1267
  • Страницы: 475-482

Influence of aging on fatigue and creep properties of polyurethane

  • Год: 2020
  • Том: 44
  • Выпуск: 2
  • 19
  • 1079
  • Страницы: 256-263

Crystallographic orientation, delay time and mechanical constants influence on thermal fatigue strength of single - crystal nickel superalloys

  • Год: 2020
  • Том: 44
  • Выпуск: 1
  • 11
  • 1076
  • Страницы: 125-136

РАЗРАБОТКА ЧИСЛЕННОЙ МЕТОДИКИ И ПРОВЕДЕНИЕ ВИРТУАЛЬНЫХ ИСПЫТАНИЙ НА ЦИКЛИЧЕСКУЮ ДОЛГОВЕЧНОСТЬ ПРИ ПОМОЩИ МЕТОДА КОНЕЧНЫХ ЭЛЕМЕНТОВ

  • Год: 2019
  • Том: 42
  • Выпуск: 6
  • 21
  • 1109
  • Страницы: 859-869

Modeling plastic deformation and damage accumulation processes in structural steels under block non-symmetric low-cycle loading

  • Год: 2019
  • Том: 42
  • Выпуск: 3
  • 4
  • 1023
  • Страницы: 359-366

Coupled thermo-electro-mechanical modeling of thermal fatigue of single-crystal corset samples

  • Год: 2019
  • Том: 42
  • Выпуск: 3
  • 2
  • 924
  • Страницы: 296-310

Sequential cold expansion and resulting beneficial residual stress prediction around adjacent fastener holes

  • Год: 2018
  • Том: 37
  • Выпуск: 1
  • 8
  • 949
  • Страницы: 92-99

Defining relations of mechanics of damaged media effected by fatigue and creep

  • Год: 2018
  • Том: 36
  • Выпуск: 1
  • 2
  • 824
  • Страницы: 147-153

Prediction of short fatigue crack propagation on the base of non-local fracture criterion

  • Год: 2017
  • Том: 31
  • Выпуск: 1/2
  • 3
  • 913
  • Страницы: 44-47

Исследование механических свойств чистого никеля и нанокомпозита "Ni-YSZ" при растяжении, сжатии и усталостной нагрузке

  • Год: 2017
  • Том: 30
  • Выпуск: 1
  • 11
  • 964
  • Страницы: 93-101

Fatigue of commercially pure titanium dental implants

  • Год: 2016
  • Том: 27
  • Выпуск: 1
  • 3
  • 802
  • Страницы: 79-89

Fatigue of commercially pure titanium dental implants

  • Год: 2016
  • Том: 27
  • Выпуск: 1
  • 3
  • 755
  • Страницы: 79-89

Influence of patch parameters on damage and residual strength of adhesively bonded composite repair under fatigue loading

  • Год: 2015
  • Том: 24
  • Выпуск: 4
  • 3
  • 774
  • Страницы: 391-402

Microstructure, strength and fatigue of an ultrafine-grained Al-Cu-Mg alloy

  • Год: 2015
  • Том: 24
  • Выпуск: 3
  • 1
  • 813
  • Страницы: 232-238

Models and prediction algorithms of fracture of structural elements for low- and high-cycle loading based on FEM

  • Год: 2015
  • Том: 23
  • Выпуск: 1
  • 2
  • 739
  • Страницы: 79-82